Slider Card by Kerry

Slider Card by Kerry

White Card - 10.5 cm x15cm (note this will be cut down a little bit)
White Card – 9 cm x 13 cm (note this will be cut down a little bit)
Contrasting Card – 10.5 cm x 15 cm – 2 pieces (note this will be cut down a little bit)
Embellishments
Template A & B
TEMPLATES FOR SLIDER CARD.pdf


1. Take the 2 pieces of the contrasting card (10.5 cm x 15 cm) and template A. Glue template A to the wrong side of one of the contrasting card pieces. Note that there will card showing on the outside of the template A. Trim off the excess card.





2. Take the other piece of contrasting card and make it the same size as the piece that the template A is glued to.
3. Then put the 2 pieces together and cut it half – using the mark as a guide. Use the picture as a guide. Lift off the pieces that are not glued to the template A and put it to one side – make sure you know which side goes where.











4. Take template B and place inside the half that has the template A glued to it – see photo. Now glue the other pieces of contrasting card (from step 3) to the template A section only.

















5. Do not put glue anywhere else on the card.
6. If you pull both ends of the slider card it should open easily.





















7. Either stamp or put a sentiment in the centre section (Template B part) of the slider.




















8. Decorate the front of the card as desired.